Need assistance? Call the experts: (727) 223-1816
OR
Sign In
Review
Outstanding trigger. Far better than original equipment. Video made installation relatively easy.
Just what the doctor ordered! Got the full MCARBO work up installed on my PF9 and it is outstanding. It turned a decent little pocket pistol into an enjoyable shooter. Thank you for your innovation and I look forward to purchasing more of your killer products soon.
Installed all your upgrades, wish the pre travel screw was longer, seems I couldn't adjust both to my liking, if I adjusted pre travel out, over travel did nothing, ended up putting back my Northwoods trigger for room. Everything else worked great, she's a joy to shoot.
I installed this trigger along with the trigger spring kit. The original trigger was horrible! It pinched my finger on the bottom when pulling and also pinched my finger on top on reset. Between the trigger shape and the heavy factory trigger springs I was consistently shooting to the right and disliked shooting this firearm. I did have to slightly shorten one of the stop screws on the trigger as there was not enough room to accommodate both trigger firing and resetting. However, The improvement of the firearm after the new trigger and springs is so considerable I still have to give it 5 stars!
Great results, turned my disappointing Kel Tech PF 9 into a real shooter. Videos are very helpful and show step by step installation. Be careful when installing the trigger bar spring. The indentation in the bar is very small. I messed up the shape of the spring leg, but M Carbo replaced it for the shipping cost,
Could not get this flat trigger to work in my PF9. After multiple adjustments it would still not hit the primer hard enough to fire a round. Took it to Shoot Straight and had there gunsmith work on it they couldn’t get it to work. Had them put in the original trigger back in and it worked fine.
This trigger is 100 times better the the factory! The videos make it easy to DIY the installation!
Great product no more pinched finger no more wide trigger add on.
First it is a vast improvement over the original equipment manufacturer or OEM. But it could use some polishing Such as the 2 screws that go into the trigger They are both the same length which Results in them sticking out of the front and back of the trigger and if you have large hands like I do you get poked like a needle. So one screw needs to be about half the length of the other so that it sits inside the trigger on the front of the trigger. (Which I ground down and made it fit)
I installed this trigger, steel rod, 20lb recoil springs, and reduced the trigger pull to 2.75. the result is amazing. I am in the car outside the range after I went thru 200 rounds with no failures and mostly on target at 25 yards. For a subcompact dao pistol that's impressive. I recommended all the pf9 upgrades from mcarbo.com
Turned a cheap pistol into a very, very good shooter. PF-9 is a very safe carry gun but factory trigger is garbage, this kits is a game changer. Recommend stainless guide rod, guide rod spring, spring kit and flat trigger. Take your time and watch the video. You will need the right size punches to make it go smooth, not a hard project.
Just installed trigger and spring upgrade. Much improved trigger pull and smoother too! Off to the range!