Need assistance? Call the experts: (727) 223-1816
OR
Sign In
Review
Easy to install. Liked the design. Fixed my stove piping problem.
Wow, unbelievable difference it's made...
It’s a great feeling to have a hand tool that works properly when needed. Making a great thing even better is always awesome
Another Ruger part I had to replace due to what looks like chinesium. This carbine was not cheap, so why the cheap parts Ruger?
After about 400 rounds,my 9mm PCC was having fte almost after every shot. Installed new ejector pin from MCARBO,working great now with Ruger or Glock mags,highly recommend to anyone having the same problem.
This afternoons mail delivered both the Ruger PC Carbine Exact Edge Extractor & the A2 Tool Steel Bolt Head Pins & Extractor Pin Kit. Within 30 minutes the old were out and the new were in. Nect stop the range. My only, semi-negative commnt is that the videos could use a little less cross selling and editorial comments, other wise A1.
Easy to install following the video posted on YouTube. I only have a limited number of rounds through it since installing, but so far not a single stovepipe. My PCC had occasional stovepipes right out of the box. I wish I would have purchased the upgraded pins when I ordered the extractor...
Gives her a different sound when the bolt drops, sings like quality. Easy install, just be sure to press down on it prior to pulling the pin, or it will send the ejector spring flying.
Simple to install and obviously far superior to the OEM. This is an absolute must upgrade along with the red recoil spring from tandenkross
Haven't run a lot of rounds yet but I can tell the difference. Very worthwhile.
I purchased this replacement rod after having issues with my PC. The part is machined perfectly and solved my issue. It was an easy install as well. I also purchased the buffer pad and installed at the same time. Thank you MCarbo for a part that is better than the original.
500 rounds and the stock one stated to not to work properly. Bought Mcarbo ejector and problem solved. 1500 rounds and cero malfunctions.
Part was easily installed
I Own both a 9 mm and a 40 caliber Ruger carbine a while back I decided to change out the ejectors Because the 40 cal was showing issues like weak ejections so I replace both of them with carbo ejectors the 9mm worked fine, but the 40 Cal ejector blew apart. I found Half laying on the table in the spring I found on the ground I don’t know what happened to the other half of it and it was working fine through the first couple of magazines and then I started having stove pipe issues that I noticed that it wasn’t there in place. this is the first time I’ve shot him since I’ve ordered them a while back. I don’t remember the exact date but I’ve done all the upgrades on these Rugers and have not shot them in a while until today 12/21/23 I will order another one. Maybe it was just faulty, but I will find out eventually what the problem is or was?
The difference is so obvious to the eye and the results are just as obvious. I have had ZERO extraction issues since I installed it.
This is a great item to add to your Ruger pc carbine. It will make your Ruger pc much more reliable.